Christie HS 2K Series Service Manual page 98

4. Remove the harnesses from the clips.
5. On the main board, remove the 13 M3 screws with a Phillips #1 screwdriver.
6. On the rear cover side, remove the two M3 screws with a Phillips #1 screwdriver.
7. Starting from the front side, lift the main board module gently to disconnect the connector on
the bottom side of the main board.
8. Take out the main board module from the projector.
9. On the I/O cover, remove the three M3 hex screws with a M3 socket driver.
10. On the I/O cover, remove the two M3 screws with a Phillips #1 screwdriver.
11. On the I/O cover, remove the two nuts with a M14 socket driver.
12. Remove the I/O cover.
13. Flip the main board module over to access the media board.
14. Remove the media board.
See Replacing the media board
HS Series 2K Service Manual—DWU1612-HS,DWU2022-HS
020-001790-01 Rev. 1 (03-2020)
Copyright ©2020 Christie Digital Systems USA Inc. All rights reserved.
on page 99.
Printed circuit boards and sensors
98