10. Disconnect the two AC inlet connectors.
11. Lift up the power supply module.
12. Release the harnesses from the cable tie.
13. Remove the five M3 screws with a Phillips #1 screwdriver securing the shielding cover on the
left of the power supply.
14. Remove the top cover interlock switch harnesses from the clips.
15. Remove the AC inlet harnesses from the clips.
HS Series 2K Service Manual—DWU1612-HS,DWU2022-HS
020-001790-01 Rev. 1 (03-2020)
Copyright ©2020 Christie Digital Systems USA Inc. All rights reserved.
Electronics
75