Calibrating The Lens; Analog Digital Convert Calibration - Christie HS 2K Series Service Manual

7. After completing the adjustment, tighten the screw on the side of the gear as indicated by the
arrow.

Calibrating the lens

Always perform a lens calibration after repairing the main board or replacing the light engine.
Warning! If not avoided, the following could result in death or serious injury.
• Do not stare into beam when the projector is on. The bright light may result in permanent eye
damage.
ID Part name
1 Inspection item
2 Criteria
1. Place the projector on a clean horizontal surface.
2. On the IR remote keypad, press Menu and select Configuration > Lens Setting.
3. Select Lens Calibration.
4. Press Enter.

Analog digital convert calibration

If the color appears abnormal after upgrading the scalar firmware, perform an analog digital convert
(ADC) calibration.
Warning! If not avoided, the following could result in death or serious injury.
• Do not stare into beam when the projector is on. The bright light may result in permanent eye
damage.
HS Series 2K Service Manual—DWU1612-HS,DWU2022-HS
020-001790-01 Rev. 1 (03-2020)
Copyright ©2020 Christie Digital Systems USA Inc. All rights reserved.
The screw
Description
Check if the lens shift is moving smoothly.
The lens shift is moving smoothly.
ABC adjustment gear
Service setups
23