Spark Plugs - BRP can-am OUTLANDER 2021 Series Operator's Manual

MAINTENANCE PROCEDURES
V07I010
1. Throttle lever
A. 2 mm (.079 in)
Tighten lock nut and reinstall protector.
With the shift lever on PARK position,
start the engine.
Check if the throttle cable is adjusted
correctly by turning handlebar fully to
the right then fully to the left. If the
engine RPM increases, readjust the
throttle lever free play.

Spark Plugs

Spark Plug Access
Remove side panels.
Unplug spark plug cables.
Spark Plug Removal
Unscrew spark plugs one turn.
CAUTION Always wear safety
goggles when using pressurized air.
Clean spark plugs and cylinder heads
with pressurized air if possible.
Unscrew spark plugs completely us-
ing a spark plug socket, then remove
them.
______________
160
A
1
219001737-010_a
RH SIDE — REAR CYLINDER
1. Spark plug
219001737-011_a
LH SIDE — FRONT CYLINDER
1. Spark plug
Spark Plug Installation
Prior to installation, make sure that
contact surfaces of cylinder heads and
spark plugs are free of grime.
Using a feeler gauge, set the spark plug
gap.
SPARK PLUG GAP
650
850
1000R
Apply a small amount of copper-based
anti-seize lubricant over spark plug
threads to prevent a possible seizure.
Screw spark plugs into cylinder heads
by hand and tighten with a torque
wrench and a proper socket.
0.8 mm to 0.9 mm
(.031 in to .035 in)
0.7 mm to 0.9 mm
(.028 in to .035 in)