BRP can-am OUTLANDER 2021 Series Operator's Manual page 171

Tire Replacement
Tires replacement should be per-
formed by an authorized Can-Am
dealer.
WARNING
– Replace tires only with the same
type and size as original tires.
– For unidirectional tread pat-
tern, ensure that the tires are
installed in the correct direction
of rotation.
– Tires should be replaced, by an
experienced person, in accor-
dance with tire industry stan-
dards and tools.
Wheel Removal
Place vehicle on a level surface.
Engage 4WD mode.
Apply the parking brake.
Loosen lug nuts then lift vehicle.
Secure vehicle on jack stands.
Remove lug nuts, then remove wheel.
Wheel Installation
At installation, it is recommended to
apply anti-seize lubricant on threads.
If tires are unidirectional, make sure to
install wheel according to tire rotation.
Carefully tighten lug nuts in a criss-
cross sequence then tighten to speci-
fication.
TIGHTENING TORQUE
Wheel lug nut
NOTICE
Always use the recom-
mended wheel lug nuts according to
the type of wheel. Using a different
nut could cause damage to the rim
or studs.
80 N•m ± 5 N•m
(59 lbf•ft ± 4 lbf•ft)
vmo2008-001-002_a
TYPICAL — ALUMINUM WHEEL
1. Wheel lug nut (closed end type)
Wheel Beadlock Inspection (If
equipped)
Wheel Beadlock Retorque
NOTICE
wrench for tightening beadlock
screws in order to avoid to damage
them.
1. Retorque all screws to specification
and according to the following tight-
ening sequence.
Beadlock
screws
219001737-001_a
TYPICAL - FINAL TIGHTENING SEQUENCE
2. Tighten screws a few turns at a
time to ensure even pressure on
the beadlock clamp ring.
______________
MAINTENANCE PROCEDURES
Do not use an impact
TIGHTENING TORQUE
11 N•m ± 1 N•m
(97 lbf•in ± 9 lbf•in)
169