EQUIPMENT
1) Windshield (If
Equipped)
Windshield Removal and
Installation
To remove the windshield, completely
unscrew both knobs, then pull the
windshield forward.
219002027-002
To install, insert the windshield arms
into their supports, then hand tighten
the knobs.
2) Operator's Seat
The seat is designed for an operator
only.
WARNING
Never allow anyone to seat as a
passenger on this vehicle.
Seat Removal
To remove the operator's seat, push its
latch upward. This latch is located un-
derneath the rear of seat.
______________
112
vmo2012-012-020_a
1. Seat latch
Pull seat upward then rearward. Con-
tinue lifting movement until you can
release the front retaining device then
completely remove seat.
Seat Installation
Insert front tabs of seat into steel
hooks of frame. When seat rests in
its position, firmly push seat down to
latch.
NOTE: A distinctive snap will be felt.
Double check that the seat is secure by
giving it a tug to confirm proper latch-
ing.
WARNING
Confirm that the operator's seat
is properly locked in position by
pulling back and up several times.
3) Passenger's Seat/
Glove Box (If Equipped)
(2-UP Models)
WARNING
Never operate the vehicle without
passenger's seat or glove box in-
stalled.
The passenger's seat is designed for a
passenger only. The integrated back-
rest supports his back during the ride.