BRP can-am OUTLANDER 2021 Series Operator's Manual page 148

MAINTENANCE PROCEDURES
Air Filter Cleaning and Oiling
CAUTION Always
propriate skin and eye protection.
Chemicals can cause a skin rash and
eye injury.
Paper Filter Cleaning
1. Ensure that the foam filter is re-
moved from paper filter.
2. Tap out heavy dust from the paper
filter.
This will allow dirt and dust to get out of
the paper filter.
NOTE: Paper filter have a limited
life span; replace filter if too dirty or
clogged.
NOTICE
It is not recommended to
blow compressed air on the paper
filter; this could damage the paper
fibers and reduce its filtration ability
when used in dusty environments.
NOTICE
Do not wash the paper fil-
ter with any cleaning solution.
Foam Filter Cleaning
1. Spray the foam filter inside and out
with a good air filter cleaner and fol-
low manufacturer's instructions.
vbs2009-012-015_a
TYPICAL - SPRAY THE FOAM FILTER
2. Dry the foam filter completely.
______________
146
wear ap-
TYPICAL - DRY
NOTE: A second application may be
necessary for heavily soiled elements.
Foam Filter Oiling
1. Make sure filter is clean. Refer to
2. Spray AIR FILTER OIL (P/N 219 700
TYPICAL - OIL THE FOAM FILTER
3. Let stand for 3 to 5 minutes.
4. Remove any excess of oil that
vbs2009-012-005
FOAM FILTER CLEANING
340) or equivalent on the foam filter
previously dried.
SERVICE PRODUCT
AIR FILTER OIL
(P/N 219 700
340)
vbs2009-012-014
could transfer to the paper filter by
wrapping the foam filter into an ab-
.