Engine Coolant - BRP can-am OUTLANDER 2021 Series Operator's Manual

Inspect radiating fins. They must be
clean, free of mud, dirt, leaves and any
other deposit that would prevent the
radiator to cool properly.
Remove as much deposits as you can
with your hands. If water is available in
proximity, try rinsing the radiating fins.
NOTE: Inner fenders can be removed
to ease cleaning.
If available, use a garden hose to rinse
the radiating fins.
CAUTION Never clean radiator
with your hands when it is hot. Let
the radiator cool down before clean-
ing.
NOTICE
Be careful not to damage
the radiating fins when cleaning. Do
not use any object/tool that could
damage the fins. The fins are pur-
posely thin parts to allow efficient
cooling. WHEN HOSING, USE LOW
PRESSURE ONLY, NEVER USE A
HIGH PRESSURE WASHER.
See an authorized Can-Am dealer, re-
pair shop or person of your own choos-
ing to check the performance of the
cooling system.

Engine Coolant

Engine Coolant Level Verification
WARNING
Check coolant level with engine
cold. Never add coolant in cooli ng
system when engine is hot.
Place vehicle on a level surface.
Remove the gauge support .
219001854-001_a
Step 1: Pull up
Step 2: Slide
Remove the coolant reservoir cap.
Do not remove the coolant reser-
voir cap if engine is hot.
With vehicle on a level surface, liquid
should be between MIN. and MAX.
level marks of coolant reservoir.
vmo2012-012-042_a
1. Engine coolant reservoir
NOTE: When checking level at tem-
perature lower than 20°C (68°F), it may
be slightly lower than MIN. mark.
Add coolant if required.
Use a funnel to avoid spillage. Do not
overfill.
Properly reinstall and tighten reservoir
cap.
Reinstall gauge support.
______________
MAINTENANCE PROCEDURES
WARNING
151