BRP can-am OUTLANDER 2021 Series Operator's Manual page 172

MAINTENANCE PROCEDURES
NOTE: It is normal that the beadlock
clamp ring flexes slightly to match the
tire bead.
Wheel Beadlock Gap Verification
1. Verify the gap between tire and
beadlock clamp ring, it should be
practically equal all around the ring.
219001737-002_a
TYPICAL
A. Gap between tire and ring
If the gap is not acceptable, see
MOUNTING ON BEADLOCK WHEELS
below.
Tire Mounting on Beadlock Wheels
(If Equipped)
1. Mount the tire on wheel.
1.1 On the opposite side of bead-
lock, apply tire mounting lube
on inner bead of tire and wheel
to ensure proper seat when in-
flating. Mount the inner bead
over the wheel like normal.
NOTICE
beadlock side only.
1.2 Seat tire outer bead in the
shoulder of the beadlock in-
ner ring and center the tire.
______________
170
Mount tire
219001737-003_a
TYPICAL
1. Tire outer bead
2. Beadlock inner ring shoulder
2. Install all beadlock screws. To avoid
cross threading, start all screws by
hand.
NOTICE
wrench
screws. The risk of screw breaking
or screw stripping is high when us-
ing an impact wrench.
TIRE
219001735-001_c
TYPICAL
3. Tighten beadlock screws as per fol-
lowing specification and sequence.
NOTE: To
on the beadlock clamp ring, tighten
from
screws a few turns at a time.
Beadlock
screws (FIRST
Sequence)
Do not use an impact
for installing
ensure even
TIGHTENING TORQUE
3 N•m ± 1 N•m
(27 lbf•in ± 9 lbf•in)
beadlock
pressure