Cvt Air Filter (850/1000R) - BRP can-am OUTLANDER 2021 Series Operator's Manual

Remove carbon deposits from the
spark arrester using a brush.
NOTICE
Use a soft brush and be
careful to avoid damaging spark ar-
rester mesh.
CAUTION Wear eye protection
and gloves.
tmo2011-001-043_a
1. Clean spark arrester
Inspect mesh of spark arrester for any
damage. Replace as required.
NOTE: Spark arrester screen replace-
ment is required only when damaged
Inspect spark arrester chamber in muf-
fler. Clean any debris as required.
Install new gasket, tail pipe and new re-
taining screws.
Reinstall muffler cover with new re-
taining screws. Tighten to specifica-
tion.
While reading this Operator's Guide, remember that:
Indicates a potential hazard that, if not avoided, could result in serious
injury or death.
Tail pipe
screws
Cover screws

CVT Air Filter (850/1000R)

CVT Air Filter Removal
1. Remove the gauge support.
219001854-001_a
Step 1: Pull up
Step 2: Slide
2. Push on tabs (3) and remove air fil-
ter.
WARNING
______________
MAINTENANCE PROCEDURES
TIGHTENING TORQUE
11 N•m ± 1 N•m
(97 lbf•in ± 9 lbf•in)
155