BRP can-am OUTLANDER 2021 Series Operator's Manual page 110

7.6" DIGITAL DISPLAY
219002027-200
Setup
Using MENU button, select SET-
TINGS and hold to enter setting menu.
Maintenance Reset
NOTE: Only when the maintenance
icon is displayed.
Using MENU button, select RES
MAINT and hold to reset maintenance.
Fault Codes
NOTE: Only when fault codes are ac-
tives.
Using MENU button, select CODES
and hold to see active and occurred
fault codes. Fault codes will be
scrolled on the Lower Display.
Speed Limiter Mode (if equipped)
Speed limiter mode allows the opera-
tor to set the desired maximum speed.
This is useful when operating in limited
speed zones.
The operator must keep the throttle de-
pressed to maintain forward speed.
Once the maximum speed is set, the
operator can vary the from stopped to
the set speed using the throttle. The
set speed will be exceeded when the
throttle is fully depressed, at that time,
the speed limiter will be temporary
deactivated (the icon will be blinking)
until vehicle speed is under or equal
the speed limiter's set point.
______________
108
As you proceed under a constant
speed setting, keep your attention
level up to maintain good situational
awareness.
Slowing down is a matter of releasing
the throttle.
Activating Speed Limiter Mode
1. Press the Gauge Switch to go to the
SETTINGS
menu.
SPEED LIM
2. Select
have a choice of
2.1 in km/h:
– -- (Unlimited)
– 30 km/h
– 40 km/h
– 50 km/h
– 60 km/h
– 70 km/h
– 80 km/h
– 90 km/h
– 100 km/h
2.2 in MPH:
– -- (Unlimited)
– 20 MPH
– 25 MPH
– 30 MPH
– 35 MPH
– 45 MPH
– 50 MPH
– 55 MPH
– 60 MPH
– 65 MPH
Speed limiter indicator will be lit.
219002008-008
TYPICAL
1. Speed limiter INDICATOR
, then you will