BRP can-am OUTLANDER 2021 Series Operator's Manual page 173

219001737-001_b
TYPICAL - TIGHTENING SEQUENCE
4. At this time check if the tire is still
centered on wheel. Reposition it if
necessary.
5. Tighten beadlock screws as per the
second torque using the same se-
quence.
TIGHTENING TORQUE
Beadlock
screws
(SECOND
Sequence)
219001737-001_b
TYPICAL - TIGHTENING SEQUENCE
NOTE: The beadlock clamp ring can
flex slightly to match the tire bead. IT
IS NORMAL.
6. Verify the gap between tire and
beadlock clamp ring, it should be
practically equal all around the ring.
8 N•m ± 1 N•m
(71 lbf•in ± 9 lbf•in)
219001737-004_a
1. Tire
2. Beadlock clamp ring edge
A. Gap equal all around beadlock clamp ring
If the gap is not acceptable,
– Loosen all screws.
– Check tire position on wheel and
reposition it if necessary.
– Restart the torquing sequence as
detailed.
7. Torque beadlock screws a final time
following the indicated sequence.
Beadlock
screws (FINAL
Sequence)
tbl2011-001-068_a
TYPICAL - FINAL TIGHTENING SEQUENCE
8. Inflate tire to seat the inner bead on
wheel. Always use safe practices,
such as a tire safety cage.
______________
MAINTENANCE PROCEDURES
TIGHTENING TORQUE
11 N•m ± 1 N•m
(97 lbf•in ± 9 lbf•in)
171