BRP can-am OUTLANDER 2021 Series Operator's Manual page 159

vmo2012-012-056_a
TYPICAL
1. Drain plug
2. Oil level plug
The oil should be level with the bottom
of the oil level hole.
Refill as required until gearbox oil level
flows through oil level hole.
Recommended Gearbox Oil
RECOMMENDED GEARBOX OIL
Scandinavia
All other countries
NOTE: The XPS oil is specially formu-
lated to meet the lubrication require-
ments of this gearbox. BRP strongly
recommends the use of its XPS oil.
However, if the XPS synthetic gear oil
is not available, use the following lubri-
cant:
GEARBOX OIL REQUIREMENT
75W 140 API GL-5 synthetic gear oil
NOTICE
Do not use another types
of oil when servicing. Do not mix
with other types of oil.
Gearbox Oil Change
NOTE: When replacing the gearbox
oil, it is recommended to clean the ve-
hicle speed sensor (VSS) at the same
time.
75W140
SYNTHETIC
GEAR OIL (EUR)
(P/N 779215)
75W140
SYNTHETIC
GEAR OIL
(P/N 779160)
______________
MAINTENANCE PROCEDURES
Place the vehicle on a level surface.
Clean the drain plug area.
Clean the oil level plug area.
Under the vehicle, place a drain pan un-
derneath the oil drain plug area.
Remove the oil level plug.
Remove the drain plug.
vmo2012-012-056_a
TYPICAL
1. Drain plug
2. Oil level plug
Let oil completely drain from gearbox.
Install the drain plug and tighten to
specification.
TIGHTENING TORQUE
Drain plug
NOTE: Clean drain plug from any
metallic particles prior to installation.
Refill gearbox with recommended oil.
NOTICE
Use ONLY the recom-
mended type of oil.
The oil should be level with the bottom
of the oil level orifice.
NOTICE
Do not overfill.
Reinstall oil level plug.
20 N•m ± 2 N•m
(15 lbf•ft ± 1 lbf•ft)
157