BRP can-am OUTLANDER 2021 Series Operator's Manual page 150

MAINTENANCE PROCEDURES
vmo2006-007-013_a
TYPICAL - RH SIDE OF ENGINE
1. Dipstick
With vehicle on a level surface and en-
gine cold, not running, check the oil
level as follows:
1. Unscrew dipstick then remove it
and wipe clean.
2. Reinstall dipstick, screw in it com-
pletely.
3. Remove and check oil level. It
should be near or equal to the up-
per mark.
3
V07C02Y
TYPICAL
1. Full
2. Add
3. Operating range
To add oil, remove dipstick. Place a
funnel into the dipstick tube to avoid
spillage.
Add a small amount of recommended
oil and recheck oil level.
______________
148
Repeat the above procedures until
oil level reaches the dipstick's upper
mark. Do not overfill.
Properly tighten dipstick.
Recommended Engine Oil
Rotax
validated using the XPS™ oil. BRP rec-
ommends the use of its XPS engine oil
or an equivalent at all time. Damages
caused by the use of an oil not suitable
for the engine may not be covered by
the BRP Limited Warranty.
1
2
® engines were developed and
XPS RECOMMENDED ENGINE OIL
General purpose
Cold temperature
Scandinavia:
4T 5W40
SYNTHETIC
BLEND
OIL (EUR)
(P/N 779290)
Other Countries:
4T 5W40
SYNTHETIC
BLEND OIL
(P/N 779133)
Scandinavia:
4T 0W40
SYNTHETIC
OIL (EUR)
(P/N 779286)
Other Countries:
4T 0W40
SYNTHETIC OIL
(P/N 779139)