Spark Plugs - BRP can-am RENEGADE 500 2015 Operator's Manual

V07I010
1. Throttle lever
A. 2 mm (.079 in)
Tighten lock nut and reinstall protector.
With the shift lever on PARK position,
start the engine.
Check if the throttle cable is adjusted
correctly by turning handlebar fully to
the right then fully to the left. If the
engine RPM increases, readjust the
throttle lever free play.

Spark Plugs

Spark Plug Access
Remove side panels.
Unplug spark plug cables.
Spark Plug Removal
Unscrew spark plugs one turn.
CAUTION Always wear safety
goggles when using pressurized air.
Clean spark plugs and cylinder heads
with pressurized air if possible.
Unscrew spark plugs completely then
remove them.
A
1
______________
MAINTENANCE PROCEDURES
vmo2006-007-029_a
RH SIDE — REAR CYLINDER
1. Spark plug
vmo2006-007-030_a
LH SIDE — FRONT CYLINDER
1. Spark plug
Spark Plug Installation
Prior to installation, make sure that
contact surfaces of cylinder heads and
spark plugs are free of grime.
Using a feeler gauge, set the spark plug
gap.
SPARK PLUG GAP
0.6 mm - 0.7 mm (.024 in - .028 in)
Apply a small amount of copper-based
anti-seize lubricant over spark plug
threads to prevent a possible seizure.
Screw spark plugs into cylinder heads
by hand and tighten with a torque
wrench and a proper socket.
TIGHTENING TORQUE
Spark plug
20 N•m ± 2.4 N•m
(15 lbf•ft ± 2 lbf•ft)
109