BRP can-am OUTLANDER 2021 Series Operator's Manual page 116

EQUIPMENT
Passenger's Seat Installation
1. Ensure the latch lever is in the open
position by pulling it towards the
front of seat.
2. Using a forward motion, insert both
front tabs of the seat into the vehicle
anchor housings.
Models with Passenger's Heated
Grips and/or Heated Visor Connector
Underneath the seat, connect the elec-
trical connector.
All Models
3. Rotate downwards to engage the
rear latch.
4. Close the latch lever by pushing it
rearwards to secure seat in posi-
tion.
5. Check if the seat is firmly secured in
position before using it.
vmo2015-007-012_a
1. Front pins
WARNING
It is of the upmost importance for
the passenger's safety that you
confirm that the passenger's seat
is properly locked in position by
pulling back and up several times.
Glove Box Installation (If Equipped)
1. Remove passenger's seat. Refer to
PASSENGER'S SEAT
2. Open glove box cover and turn han-
dle to the unlock position.
______________
114
in this section.
3. Align and insert glove box latching
system into this vehicle's "LINQ"
opening.
vmo2015-007-011_a
1. Glove box latch
2. "LINQ" opening
4. Turn handle to the lock position.
vmo2013-007-007_a
TYPICAL
1. Latch
5. Close cover and verify if glove box is
locked in position.
Glove Box Removal
1. Unlock latch on each side of glove
box and open lid.
2. Turn latch counter clockwise to un-
lock.