BRP can-am OUTLANDER 2021 Series Operator's Manual page 111

Hold menu button to confirm selected
speed limit.
NOTE: Activating speed limiter mode
of operation only limits the maximum
speed available when depressing the
throttle. The throttle must be held in to
maintain forward speed. Speed can be
varied from idle up to the set speed us-
ing the throttle once the speed limiter
function is activated.
Deactivating Speed Limiter Mode
To deactivate speed limiter mode, in
SETTINGS
, select
then select the -- (unlimited) limit.
Speed/RPM
The speed and RPM display can be
swapped.
Using MENU
SPEED/RPM and hold button to
invert speed and RPM display.
Unit Selection
This multifunction gauge is factory pre-
set in Imperial units but it is possible to
change it to Metric units.
Using MENU button, select UNITS
and hold button to change units.
Reset Stats
Using MENU button, select RESET
STAT and hold to reset.
Setting Brightness
The brightness of the LCD display can
be adjusted.
Using MENU button, select BRIGHT-
NESS and hold MENU button to
change brightness.
Using MENU button, adjust brightness
then push and hold MENU button to ac-
knowledge selection.
SPEED LIM
and
button, select
______________
Setting Clock
Using MENU button, Select CLOCK
and hold to change time.
1. Press MENU button to select clock
display.
2. Push and hold MENU button for 1
second.
3. Press MENU button to select 12:00
AM PM or 24:00 time base (time
flash).
4. Push and hold MENU button to ac-
knowledge selection.
5. Press MENU button to change
hours (hours flash).
6. Push and hold MENU button to ac-
knowledge hour selection
7. Push MENU button to change to
minutes (minutes flash).
8. Press and hold MENU button to ac-
knowledge minutes selection.
Setting Language
The gauge display language can be
changed. Refer to an authorized
Can-Am dealer for language availability
and to setup the gauge to your prefer-
ence.
DPS Modes
The lower display can show which DPS
mode is active. Refer to
RIDE
.
7.6" DIGITAL DISPLAY
TUNE YOUR
109