Table of Contents
Advertisement
Chapter 5: Verifying the Hardware Operations
awplus> show stack
Virtual Chassis Stacking summary information
ID
Pending ID
1
-
Operational Status
Stack MAC address
awplus>
awplus> enable
awplus# configure terminal
Enter configuration commands, one per line. End with CNTL/Z
awplus#
130
MAC address
eccd:6dd1:64a2
Figure 90. SHOW STACK Command
5. Review the following items:
If the Operational Status is "Stacking Hardware Disabled," the
VCStack feature is already disabled on the switch. Go to "Verifying
Support for the Ethernet Line Cards" on page 133.
If the Operational Status is "Standalone Unit," the VCStack feature
is enabled on the unit. You need to disable it by performing the
steps in the rest of this procedure to use the chassis as a stand-
alone switch. The status says "standalone" because the switch is
functioning as a stack of one switch.
6. Move to the Global Configuration mode by entering the ENABLE and
CONFIGURE TERMINAL commands, as shown in Figure 91.
Figure 91. Moving to the Global Configuration Mode
7. To. disable the VCStack feature on the switch, enter the NO STACK
ENABLE command, which has this format:
id
no stack
enable
The ID parameter is the ID number of the switch, displayed on the ID
LED. Replace the parameter with whatever number is on the ID LED.
For example, if the Switch ID LED number is 1, you would enter the
command as follows:
awplus(config)# no stack 1 enable
This confirmation prompt in Figure 92 on page 131 is displayed.
Priority
Status
128
Ready
Stacking Hardware Disabled
eccd:6dd1:64a2
Role
Active Master
Advertisement
Table of Contents
