Starting A Local Management Session; Figure 88: Connecting The Management Cable To The Console Rs-232 Port - Allied Telesis SwitchBlade x908 GEN2 Installation Manual

Starting a Local Management Session

To start a local management session on the chassis, perform the following
procedure:
1. Connect the RJ-45 end of the management card included with the
switch to the Console RS-232 port on the management panel. Refer to
Figure 88.
Figure 88. Connecting the Management Cable to the Console RS-232 Port
2. Connect the other end of the cable to an RS-232 port on a terminal or
personal computer with a terminal emulation program.
3. Configure the VT-100 terminal or terminal emulation program as
follows:

Baud rate: 115,200 bps

Data bits: 8
 Parity: None
 Stop bits: 1
 Flow controller: None
SBx908 GEN2 Installation Guide for Stand-alone Switches
127