Table of Contents
Advertisement
Chapter 4: Powering On the Chassis
104
Figure 68. Stripping the Power Wires
Note
You must use stranded wires with the terminal lugs. You may not
use solid wires.
2. Insert the power wires into the terminals included with the power
supply and use a crimping tool to secure the wires to the terminals.
See Figure 69.
Figure 69. Attaching the Power Wires to the Straight Terminal Lugs
3. Verify that the On/Off switch on SBxPWRSYS1-80 Power Supply is in
the Off position. Refer to Figure 60 on page 97.
4. Use a #1 Phillips-head screwdriver to loosen the two screws on the
plastic cover over the positive and negative terminals on the power
supply and slide the cover to the right, as shown in Figure 70 on page
105. You may need to lift the locking handle slightly to access the
bottom screw.
Advertisement
Table of Contents
