Table of Contents
Advertisement
Chapter 6: Cabling the Networking Ports
Installing and Cabling Fiber Optic Transceivers
138
Table 15 lists the types of fiber optic transceivers that are supported by the
XEM2 line cards. Refer to the product datasheet for a list of approved
transceivers.
Table 15. XEM2 Line Cards and Fiber Optic Transceivers
Ethernet Line Card
XEM2-8XSTm
XEM2-12XS
XEM2-4QS
XEM2-1CQ
Please review "Guidelines to Handling Fiber Optic or Twisted Pair
Transceivers" on page 137 before performing the procedure.
Your transceivers may look different than those shown in the following
illustrations.
Warning
The temperature of an operational transceiver can exceed 70° C
(158° F). Exercise caution when removing or handling transceivers
with unprotected hands. E43
To install a fiber optic transceiver in an Ethernet line card, perform the
following procedure:
1. Select a slot in the XEM2 line card for the transceiver.
2. If the selected slot has a dust cover, remove it.
3. Remove the transceiver from its shipping container and store the
packaging material in a safe location.
4. Orient the transceiver and slide it into the slot until it clicks into place.
The correct orientation depends on the line card and transceiver:
XEM2-8XSTm or XEM2-12XS Line Card - To install a transceiver
in an odd numbered slot, position its handle on the right. To install
a transceiver in an even numbered slot, position its handle on the
left. Refer to Figure 98 on page 139.
Fiber Optic Transceiver
1Gbps SX or LX SFP
10Gbps SR or LR SFP+
1Gbps SX or LX SFP
10Gbps SR or LR SFP+
40Gbps QSFP+
100Gbps SR or LR QSFP28
Advertisement
Table of Contents
