Table of Contents
Advertisement
C.3
INSTALLING OPTIONAL FAST ETHERNET
INTERFACE MODULES
Figure C-3
shows the locations of the Fast Ethernet Interface Module
connectors for ports 7 and 8.
Primary
Power
Supply
Figure C-3 Fast Ethernet Interface Module Connector Location
To install a Fast Ethernet Interface Module in port slot 7 or 8, proceed as
follows:
The FE-100F3 uses Class 1 lasers. Do not use optical
!
instruments to view the laser output. The use of optical
CAUTION
instruments to view laser output increases eye hazard. When
viewing the output optical port, power must be removed from
the network adapter.
The Fast Ethernet Interface Module and the 2H22-08R are
!
sensitive to static discharges. Use an antistatic wrist strap and
observe all static precautions during this procedure. Failure to
CAUTION
do so could damage the module or the 2H22-08R.
2H22-08R SmartSwitch 2208 User's Guide
Installing Optional Fast Ethernet Interface Modules
TOP VIEW WITHOUT COVER
FRONT PANEL
Redundant
Power
Supply
Optional Fast Ethernet
Interface Modules
Connectors
Page C-7
Advertisement
Table of Contents
Troubleshooting
