Cabletron Systems 2208 User Manual page 153

When installing an FE-100FX or FE-100F3 module into the
!
2H22-08R, remove the rubber plug on the module before
CAUTION
proceeding.
3. See Figure
allow room for the Fast Ethernet Interface Modules to be aligned over
the connector.
In the following step, take care when inserting the Fast Ethernet
!
Interface Module into the Motherboard connector, so that the
CAUTION
pins do not bend. Otherwise, the Fast Ethernet Interface Board
and the Motherboard could be damaged.
4. Carefully lower the Fast Ethernet Interface Module onto the standoffs
while inserting the module connector into the associated motherboard
connector.
7
Figure C-5 Installing the Fast Ethernet Interface Module
2H22-08R SmartSwitch 2208 User's Guide
Installing Optional Fast Ethernet Interface Modules
C-5. Gently pull the faceplate of the 2H22-08R forward to
8
Module
Module
Connector
Rear
Standoff
Motherboard
Connector
Front
Standoffs
Page C-9
2251-39