Cabletron Systems 2208 User Manual page 147

To remove the chassis cover, proceed as follows:
TURN OFF THE 2H22-08R BY UNPLUGGING BOTH POWER
CORDS FROM THE REAR OF THE CHASSIS.
AM HINTEN DES 2H22-08R STECHEI ABZIEHEN UM AUS
ZU SCHALTEN.
APAGUE EL 2H22-08R DESENCHUFE EL CABLE DE LA
UNIDAD.
Before performing step 1, mark the cables connected to the
2H22-08R according to their associated port numbers. This is
TIP
recommended for ease of reinstallation.
1. Disconnect all network cables attached to the 2H22-08R.
2. If the 2H22-08R is rack mounted, remove it from the rack and remove
the rackmount brackets (refer to
3. Use a Phillips screwdriver to remove the screws attaching the cover to
the chassis. (See
4. Remove the cover by sliding it back until it clears the front of the
chassis and then lifting it straight up and off the chassis.
2H22-08R SmartSwitch 2208 User's Guide
Chapter
Figure C-1.)
Removing the Chassis Cover
3).
Page C-3