Cabletron Systems 2208 User Manual page 152

Appendix C: Optional Installations and Mode Switch Bank Settings
When installing Fast Ethernet Interface Modules in both port
slots 7 and 8, remove the coverplates from both slot openings.
TIP
In the following instructions, the optional module is shown
being installed in port slot 8.
1. Remove the coverplate from the port slot where the Fast Ethernet
Interface Module is to be installed. Refer to
follows:
a. Remove the two screws fastening the coverplate to the standoffs.
Save the screws.
b. Lift and remove the coverplate from the top of the front standoffs.
Coverplate
7
2. Remove the screw from the rear standoff. Save the screw.
Page C-8
8
Figure C-4 Coverplate Removal
2H22-08R SmartSwitch 2208 User's Guide
Figure C-4 and proceed as
Rear
Standoff
Front
Standoffs
2251-38