C.2.1
Setting the Mode Switch
Figure C-2
shows the location of the mode switches and the switch
settings for normal operation. These switches are set at the factory and do
not need to be changed.
TOP VIEW WITHOUT COVER
Primary
Power
Supply
Flash
DRAM
Figure C-2
Switch definitions and positions are as follows:
•
Switches 1 through 4 – For Cabletron Systems use only.
•
Switch 5 – COM Port Autobaud. The default (OFF) position enables
Autobaud sensing on the COM port for Local Management sessions.
Changing the switch to the ON position disables Autobaud sensing and
sets the COM port to 9600 baud for Local Management sessions.
2H22-08R SmartSwitch 2208 User's Guide
Redundant
Power
Supply
FRONT PANEL
Mode Switch Location/Component Layout
Removing the Chassis Cover
MODE SWITCH BANK
8
7
6
5
4
3
2
1
OFF
ON
2251-05
Page C-5