Using The Reset Button - Cabletron Systems 2208 User Manual

Chapter 4: Troubleshooting
4.4

USING THE RESET BUTTON

The RESET button, located to the left of the COM port on the 2H22-08R,
(refer to Figure
NVRAM.
The RESET button may be used in conjunction with Mode
NOTE
Switch 7 (Clear NVRAM), described in
user-entered parameters such as IP addresses and
Community Names and to replace them with the 2H22-08R
default settings. It is only necessary to use this method of
clearing NVRAM when it is not possible to access Local
Management.
Clearing NVRAM may also be performed via Local
Management.
to perform this procedure.
Pressing the RESET button resets the device, and all current
!
switching being performed by the device is halted. A network
CAUTION
downtime of up to two minutes will result from this action.
To reset the 2H22-08R processor, press and release the RESET button.
The device processor goes through a reset process of approximately 20
seconds. Additional downtime may be added as the 2H22-08R reenters
the network.
Page 4-6
4-3) resets the 2H22-08R processor without affecting the
Section
2H22-08R
Reset Button
Figure 4-3 RESET Button
2H22-08R SmartSwitch 2208 User's Guide
5.7.11, Clearing NVRAM, describes how
PWR
CPU
RESET
COM
Appendix C, to clear