Installing Optional Fast Ethernet Interface Modules - Cabletron Systems 2H28-08R User Manual

Appendix C: Optional Installations and Mode Switch Bank Settings
C.3 INSTALLING OPTIONAL FAST ETHERNET
INTERFACE MODULES
Figure C-3 shows the locations of the Fast Ethernet Interface Module
connectors for ports 7 and 8.
Figure C-3 Fast Ethernet Interface Module Connector Location
To install a Fast Ethernet Interface Module in port slot 7 or 8, proceed as
follows:
The FE-100F3 uses Class 1 lasers. Do not use optical
!
instruments to view the laser output. The use of optical
CAUTION
instruments to view laser output increases eye hazard. When
viewing the output optical port, power must be removed from
the network adapter.
The Fast Ethernet Interface Module and the 2H28-08R are
!
sensitive to static discharges. Use an antistatic wrist strap and
observe all static precautions during this procedure. Failure to
CAUTION
do so could damage the module or the 2H28-08R.
C-6
TOP VIEW WITHOUT COVER
Primary
Power
Supply
FRONT PANEL
2H28-08R SmartSwitch 2208 User's Guide
Redundant
Power
Supply
Optional Fast Ethernet
Interface Modules
Connectors