Setting The Reset Peak Utilization - Cabletron Systems 2208 User Manual

Flash Memory Installed (Read-only)
Indicates the amount of FLASH memory installed in the 2H22-08R and
how much is currently available.
DRAM Installed (Read-only)
Indicates the amount of DRAM installed in the 2H22-08R and how much
is currently available.
NVRAM Installed (Read-only)
Indicates the amount of NVRAM installed in the 2H22-08R and how
much of it is currently available.
Current Switch Utilization (Read-only)
Shows the percentage of the device's switching capacity currently being
used.
Peak Switch Utilization (Read-only)
Shows the peak percentage of device's switching capacity used, since the
last reset.
Reset Peak Switch Utilization (Toggle)
Allows you to reset the Peak Switch Utilization field. The switch may be
set to either YES or NO as described in
Peak Switch Utilization field to the current system traffic.

5.13.1 Setting the Reset Peak Utilization

To set the Reset Peak Utilization field to YES or NO, proceed as follows:
1. Use the arrow keys to highlight the Reset Peak Switch Utilization
field.
2. Press the SPACE bar to select YES or NO.
3. Use the arrow keys to highlight the SAVE command at the bottom of
the screen.
4. Press ENTER. The message "SAVED OK" displays.
2H22-08R SmartSwitch 2208 User's Guide
System Resources Screen
Section 5.13.1. YES resets the
Page 5-51