Completing A Fresh Windows Nt 4.0 Installation From Cd-Rom - Adaptec P2280A Manual

Completing a Fresh Windows NT 4.0 Installation
From CD-ROM
1
Insert the Windows NT 4.0 CD into the CD-ROM drive.
2
Start your system. Press the F6 key when you see the following
message: "Setup is inspecting your computer's hardware
configuration..."
If you do not see this message, your system may not be setup
to boot from a CD-ROM. You will need to install from floppy
disks. See Completing a Fresh Windows NT 4.0 Installation From
Floppy Disk on page 2-2.
3
When prompted, press S to specify an additional device.
4
Press Enter to select Others; insert the Ultra160 Family
Manager Set disk for Windows in your floppy disk drive.
5
Using the arrow keys, select the following driver and press
Enter:
Adaptec Ultra160 Family PCI SCSI Controller (NT4.0)
6
To add other host adapters that are not part of the Ultra160
Family, press S and repeat from Step 4 for each additional
adapter and insert the appropriate driver disk. The Adaptec
Ultra160 Family host adapters use the same driver; it is not
necessary to install the driver again.
7
Press Enter to continue with the Windows NT operating
system setup. Follow the instructions on-screen and in the
Windows NT documentation to complete the installation.
Microsoft Windows NT Installation
2-3