Completing The Slimscsi Installation In Windows Nt; If Windows Nt Is Not Installed On Your Pc - Adaptec APA-1460A User Manual

SlimSCSI 1460 Adapter User's Guide
Completing the SlimSCSI Installation in
Windows NT
The SlimSCSI adapter is supported under Windows NT version 3.51
and higher.
Note:
Windows NT 3.51 does not support hot plugging or hot
swapping. This means that the SlimSCSI adapter and the
devices connected to it must be plugged in and powered
before you start Windows NT and that you cannot remove
the adapter (or other PC Cards) while Windows NT is
running.

If Windows NT Is Not Installed on Your PC

If Windows NT is not already installed on your PC, install it now
and then continue with the instructions in the next section, If
Windows NT Is Installed on Your PC.
Follow these steps if you need to install Windows NT from a
CD-ROM drive connected to your SlimSCSI adapter:
1
Insert the SlimSCSI adapter in a PC Card slot, connect the
CD-ROM drive to it, and turn the drive
Be sure the CD-ROM drive is terminated, if it is the last (or only)
SCSI device on the bus. Also, be sure that you have installed
your PC's version of DOS Card and Socket Services.
2
Boot the PC to DOS and insert the EZ-SCSI diskette #2 in the
PC's floppy drive.
3
At the DOS prompt, change to the drive letter of the floppy
drive (usually a:), type dosinst, and press Enter.
4
Follow the instructions that appear on the screen. EZ-SCSI will
install the drivers required by the CD-ROM drive.
8
ON
.
ON