Laser Safety Information - Topcon ES-62 Instruction Manual

LASER SAFETY INFORMATION

ES is classified as the following class of Laser Product according to IEC Standard Publication 60825-1 Ed.3.0:
2014 and United States Government Code of Federal Regulation FDA CDRH 21CFR Part 1040.10 and 1040.11
(Complies with FDA performance standards for laser products except for deviations pursuant to Laser Notice
No.50, dated June 24, 2007.)
Device
EDM device
in objective lens
Laser plummet (option)

• EDM device is classified as Class 3R Laser Product when reflectorless measurement is selected. When the
prism or reflective sheet is selected in Config mode as target, the output is equivalent to the safer class 1.

Warning
• Use of controls or adjustments or performance of procedures other than those specified herein may result in
hazardous radiation exposure.
• Follow the safety instructions on the labels attached to the instrument as well as in this manual to ensure
safe use of this laser product.
AVOID EXPOSURE-Laser radiation
is emitted from this aperture.
Laser beam
emitted
from here
*: only for instruments with laser plummet (option)
• Never intentionally point the laser beam at another person.The laser beam is injurious to the eyes and skin.
If an eye injury is caused by exposure to the laser beam, seek immediate medical attention from a licensed
ophthalmologist.
• Do not look directly into the laser beam. Doing so could cause permanent eye damage.
• Do not stare at the laser beam. Doing so could cause permanent eye damage.
• Never look at the laser beam through a telescope, binoculars or other optical instruments. Doing so could
cause permanent eye damage.
• Sight targets so that laser beam does not stray from them.
Light beam used for measurement
(When reflectorless measurement is selected in Config mode)
Light beam used for measurement
(When prism or reflective sheet is selected as target in Config
mode)
Laser-pointer
Laser beam
emitted
from here*
LASER RADIATION
AVOID DIRECT EYE EXPOSURE
MAX 5mW LD 625-695nm
CLASS3R LASER PRODUCT
IEC 60825-1 Ed.3.0: 2014
ix
Laser class
Class 3R
Class 1
Class 3R
Class 2