Topcon ES-62 Instruction Manual page 109

5
Measure the second and third points in the same
way. *1)
The display changes to PT# input in the plane
offset measurement.
Input point number if necessary.
6
Press the {F4} (MEAS) key.
The instrument calculates and displays coordinate
and distance value of cross point between
collimation axis and of the plane. *2)
7
Collimate the edge (P0) of the plane. *3), 4)
8
To show the slope distance (SD), press the {
key.
• Each time pressing the {
distance, relative elevation and slope distance are
shown in sequence.
• To show coordinate value of point P0, press the
{ } key.
9
Press the {F3} (YES) key. Next offset point
number will be displayed.
10
To escape the measuring, press the {ESC} key.
The display returns to the next point number in
data collect mode.
*1) In case the calculation of plane was not successful by the measured three points, error displays. Start
measuring over again from the first point.
*2) Data display is the mode beforehand of offset measurement mode.
*3) Error will be displayed when collimated to the direction which does not cross with the determined plane.
*4) The reflector height of the target point P0 is set to zero automatically
}
} key, horizontal
7-15
Collimate
PLANE
P2
N002#:
{F1}
SD:
MEAS
Collimate
PLANE
P3
N003#:
{F1}
SD:
MEAS
PLANE
PT#
PCODE :TOPCON
INPUT SRCH
{F4}
HR:
HD:
VD:
>OK?
Collimate
HR:
P0
HD:
VD:
>OK?
V :
HR:
SD:
>OK?
{F3}
PLANE
PT#
PCODE :TOPCON
INPUT SRCH
{ESC}
PT#
PCODE :TOPCON
R.HT
INPUT SRCH MEAS ALL
7 DATA COLLECTION
m
--- NP/P ---
m
--- NP/P ---
→ PT-11
--- MEAS
80°30'40"
54.321 m
10.000 m
[YES][NO]
75°30'40"
54.600 m
-0.487 m
[YES][NO]
90°30'40"
75°30'40"
54.602 m
[YES][NO]
→ PT-12
--- MEAS
→ PT-12
: 1.200 m