Setting Parameter Of Data Collect [Config.] - Topcon ES-62 Instruction Manual

7.7 Setting Parameter of Data Collect [CONFIG.]

In this mode, the following settings of data collect mode are possible.
 Setting Items
Menu
F1:DIST MODE
F2:HD/SD
F3:MEAS. SEQ.
F1:DATA CONFIRM
F2:COLLECT SEQ.
F3:NEZ AUTO. CALC
 How to Set Items
Example Setting: DATA CONFIRM: YES
Operating procedure
1
Press the {F3} (CONFIG.) key from the data
collect menu 2/2.
The CONFIG menu 1/2 is shown.
2
Press the {F4} (P ) key to display the CONFIG
↓
menu 2/2.
3
Press the {F1} (DATA CONFIRM) key.
[ ] indicates the current setting.
4
Press the {F1} (YES) key.
5
Press the {F4} (ENTER) key.
Selecting Item
Select Fine /Coarse(1) /Coarse(10) mode in distance
measurement mode.
The unit to be displayed is as follows.
FINE / CRS(1) /
CRS(10)
Fine mode: 1mm (0.2mm)
Coarse (1) mode: 1mm
Coarse (10) mode: 10mm
Select the distance measurement mode Horizontal
HD/SD
Distance or Slope distance.
Select to set measurement mode for distance
N-TIMES /
SINGLE / REPEAT
measurement.
It is possible to confirm the result of measuring data
YES/NO
before the data is recorded.
Select the procedure of data collection.
[EDIT
→
[EDIT MEAS] /
entering other data.
→
[MEAS EDIT]
[MEAS
entering other data.
It is possible to calculate coordinate value of data collected
ON/OFF
and store it into coordinate data file in every data collection.
7-21
Contents
→
MEAS]: Measurement is carried out after
→
EDIT]: Measurement is carried out before
Operation
DATA COLLECT
F1:SELECT A FILE
F2:PCODE INPUT
F3:CONFIG.
{F3}
CONFIG.
F1:DIST MODE
F2:HD/SD
F3:MEAS. SEQ.
{F4}
CONFIG.
F1:DATA CONFIRM
F2:COLLECT SEQ.
F3:NEZ AUTO.CALC P
{F1}
DATA CONFIRM
F1:YES
[F2:NO ]
{F1}
DATA CONFIRM
[F1:YES]
F2:NO
{F4}
7 DATA COLLECTION
Display
2/2
↓
P
1/2
↓
P
2/2
↓
ENTER
ENTER