To Delete Coordinate Data - Topcon ES-62 Instruction Manual

6
Enter the horizontal distance (OFFSET) from
"END" point.
To select directions, press {F1} (LEFT) to move to
the left and {F2} (RIGHT) to the right.
7
Set with {ENT} key.
The conditions for calculating coordinate data will
be displayed.
8
Press {F1} (OK) to calculate coordinate data.
After the coordinate data is calculated, the
procedure will move onto coordinate point/
description entries.
 The procedures below will be the same as the
ones for entering coordinates directly
(COORDINATE).
 The calculated value will be displayed for the
coordinate data. Set with {ENT} key.

19.5.2To Delete Coordinate Data

Operating procedure
1
Select {F2} (DELETE POINT).
2
Select the type of data to delete.
{F1} (DESIGN PT)
•••••• Coordinate data entered directly and
recorded for addition of coordinates
{F2} (MEASUREMENT PT)
•••••• Coordinate data observed and recorded
through layout, TOPO, etc.
Enter
ENTER FROM END PT#
OFFSET,
{F1} or
{F2}
LEFT RIGHT
{ENT}
START
END
{F1}
ENTER NEW POINT:
PT#:
DESC:
Enter PT#,
ENTER NEW POINT:
Enter
PT#:
DESC
DESC:
{ENT}
{ENT}
1.COORDINATES
2.REFLINE
3.TAPE
Operation
1.ADD POINT
2.DELETE POINT
3.VIEW POINT
{F2}
1.DESIGN PT
2.MEASUREMENT PT
{F1}
ENTER PT TO DEL
or
PT#:
{F2}
DESC:
19-20
19 TOP FIELD MODE
R = 5.000_
[P01
[P02
R : 5.000 m
OK EDIT
[_
[
ALP
[P03
[POINT_
ALP
N [ 10.000 ]
E [ 5.000 ]
Z [ 0.000 ]
ENTER
PT#: [P03
STORED!
JOB [JOB1
[1] [2] [3]
Display
[1] [2] [3]
[1] [2]
[_
[
↑ ↓
ALP CLR
m
CLR
]
]
↓
]
]
CLR
]
]
CLR
]
]
↓
]
]