Select A File; Initialize Road Data - Topcon ES-62 Instruction Manual

11
Press the {F3} (NEZ) key.
The coordinate data is shown.
12
Press the {F4} (NEXT) key to set next layout point.
*1) If not selecting offset, press the {ENT} key.

6.6.7 Select a File

To set the coordinates to be used for the Occupied Point and Backsight Point, carry out the following
operating procedure.
Operating procedure
1
After pressing the {MENU} key, press the {F4} (P
{F2}, {F4}key to get the programs menu on page 2/
2.
2
Press the {F3}, {F2} key.

( Refer to "Select a file" on page 6-26.)
3
Press the {F3} key.
4
Enter the name of the file being used (or select it
from the list).
5
Press the {ENT} key.

6.6.8 Initialize ROAD data

To initialize the data, carry out the following operating procedure.
Operating procedure
1
After pressing the {MENU} key, press the {F4} (P
{F2}, {F4}key to get the programs menu on page 2/
2.
2
Press the {F3}, {F3} key.

( Refer to "Initialize ROAD data" on page 6-26.)
3
When the {F4} (YES) key is pressed, all ROAD
DATA with the exception of the coordinate data file
is erased.
Press the {F4} key.
{F3}
MODE
{F4}
Operation
),
↓
{MENU}
PROGRAMS
{F4}
{F2}
{F4}
{F3}
SETOUT
{F2}
{F3}
SELECT A FILE
INPUT LIST --- ENTER
Select a file
{ENT}
Operation
),
↓
{MENU}
PROGRAMS
{F4}
{F2}
{F4}
{F3}
INITIALIZE DATA
{F3}
{F4}
6-36
6 SPECIAL MODE (Menu Mode)
N * 70.000 m
E : 50.000 m
ANG NP/P NEXT
Display
F1:AREA
F2:POINT TO LINE
F3:ROAD
F1:OCC&BS
F2:SETOUT ROAD
F3:SELECT A FILE
FN:__________
Display
F1:AREA
F2:POINT TO LINE
F3:ROAD
ERASE ROAD DATA
>OK ? [NO][YES]
2/2
P↓
2/2
P↓