Input Road Data - Topcon ES-62 Instruction Manual

6.6.2 Input Road Data

[ROAD] is made up of four types of components: LINE, CURVE, SPIRAL and POINT.
To input the required components, carry out the following operating procedure.
Operating procedure
1
After pressing the {MENU} key, press the {F4} (P
{F2}, {F4}key to get the programs menu on page 2/
2.
2
Press the {F3}, {F1}, {F2},{F1} key.

( Refer to "Input road data" on page 6-26.)
 The amount of input data varies depending on the type of data, up to a maximum of 30.
(In the case of POINT input only, the maximum is 9 points including end point.)
 An error may occur when entering a combination of POINT and other components if the amount of data
entered exceeds the maximum amount allowed for internal calculations. If this happens, please reduce
the amount of input data.
 Input LINE data
Operating procedure
1
To input LINE data, press the {F1} key. *1)
2
Input LENGTH.
3
Press the {ENT} key.
4
Input AZIMUTH.
5
Press the {ENT} key.
*1) The number at the top right of the screen shows the amount of data currently entered.
Operation
),
↓
{MENU}
PROGRAMS
{F4}
{F2}
{F4}
{F3}
{F1}
{F2}
{F1}
Operation
{F1}
LINE
Input
LINE
LENGTH
{ENT}
Input
AZIMUTH
{ENT}
6-28
6 SPECIAL MODE (Menu Mode)
Display
F1:AREA
F2:POINT TO LINE
F3:ROAD
F1:LINE
F2:CURVE
F3:SPIRAL
F4:POINT
Display
F1:LINE
F2:CURVE
F3:SPIRAL
F4:POINT
L = 0.000
AZ: 0°00'00"
--- --- [CLR] [ENT]
L : 100.000 m
AZ= 0°00'00"
--- --- [CLR] [ENT]
<SET!>
2/2
P↓
01
m
01