Connecting The Interface Cable - FujiFilm CR-IR 357 Service Manual

5.2

Connecting the Interface Cable

CAUTION
A telephone cable should not be plugged into the I/F cable connector. The type of
cable compatible with this machine is an IEC950/UL1950-listed cable only.
 NOTE 
For the I/F cable, only the straight cable of UTP type should be used.
1.
Connect the I/F cable to the I/F cable connector of the machine.
014-204-01E
11.10.2005 FM4750
2.
Consult the user to check the installation conditions of the machine, cable wiring
locations and so on. When the I/F cable is to be drawn out from the right-hand
side of the machine, pass the cable through the right-hand slot, and when it is to
be drawn out from the rear of the machine, pass it through the rear slot.
3.
Connect the I/F cable to the switching hub.
CR-IR 357 Service Manual
IN-21
IN-21