Appendix 8. Corrective Procedure To Be Performed After Improper Ru Pc- Tool Installation - FujiFilm CR-IR 357 Service Manual

Appendix 8. Corrective Procedure to be
Performed after Improper RU PC-
TOOL Installation
If "For Client PC" is inadvertently chosen when the RU PC-TOOL is to be installed, install the
RU PC-TOOL as directed below.
When the RU PC-TOOL installation procedure is improperly performed, use either of the
following corrective procedures:
 Abort the installation process and then perform the installation
procedure again.
If you find in the middle of the RU PC-TOOL installation process that "For Client PC" is
inadvertently chosen, you can abort the installation process.
In this instance, abort the installation process and install the RU PC-TOOL. For details
on the procedure, see "Appendix 8-1 Corrective Procedure 1."
{IN: Appendix 8-1_Corrective Procedure 1}
 Delete the CLIENT PC-TOOL and then perform the installation procedure
again.
If you complete the RU PC-TOOL installation process with "For Client PC" inadvertently
chosen, the CLIENT PC-TOOL is installed.
In this instance, delete the CLIENT PC-TOOL with the RU-APL CD-ROM and then
install the RU PC-TOOL. For details on the procedure, see "Appendix 8-2 Corrective
Procedure 2."
{IN: Appendix 8-2_Corrective Procedure 2}
014-204-01E
11.10.2005 FM4750
1. Corrective Procedure 1
This section describes the procedure for aborting the installation process and installing the
RU PC-TOOL.
1.
If you clicked [SET] with "For Client PC" chosen, click [Cancel] in a window that
opens next.
2.
When a message appears to ask whether you want to cancel the installation
process, click [Yes].
3.
Click on [Finish].
4.
Install the RU PC-TOOL as directed under "Appendix 7-2 Installing the RU PC-
TOOL."
{IN: Appendix 7-2_Installing the RU PC-TOOL}
CR-IR 357 Service Manual
Appx_IN-46
Appx_IN-46