FujiFilm CR-IR 357 Service Manual page 51

9.
Insert the rear bracket from the rear of the machine between the nut of the
adjustable foot and the bottom of the machine. While pushing the bracket against
the machine, fasten the nut of the adjustable foot for retaining.
 NOTES 
- Be sure to fasten the nut while pushing the bracket against the machine. If the bracket
is pushed insufficiently, the machine may not be able to be properly retained.
- When fastening the nut of the adjustable foot, exercise care not to cause an aperture
between the two nuts. The bracket might not be able to be properly retained.
REFERENCE
The front bracket (for use on the front face) and the rear bracket (for use on the rear
face) of the anti-topple retainer have different shapes. Although they are of similar
shapes when viewed from the surface, you can distinguish them by checking from the
back.
The front bracket has nuts welded on the inner side.
The rear bracket has no nut welded on the inner side.
014-204-01E
11.10.2005 FM4750
CR-IR 357 Service Manual
Appx_IN-7
Appx_IN-7