FujiFilm CR-IR 357 Service Manual page 53

12.
Once pull out the machine. Adjust the height of the bracket retained on the floor
by adding a spacer. Then move the machine again.
 NOTE 
Check the portion where the bracket retained on the floor is in contact wit the bracket on
the rear of the machine. Add a spacer of 1mm or 2mm thickness accordingly.
014-204-01E
11.10.2005 FM4750
13.
Check to make sure that the spacer of 1mm thickness cannot be inserted into an
aperture between the bracket retained on the floor and the bracket mounted on
the machine.
 NOTES 
- If the spacer of 1mm thickness can be inserted into an aperture between the bracket
retained on the floor and the bracket mounted on the machine, the spacer should be
removed and the height need be adjusted again. Take the procedure 14.
- If the spacer of 1mm thickness cannot be inserted into an aperture between the bracket
retained on the floor and the bracket mounted on the machine, the procedure 14 need
not be taken. Proceed to the procedure 15.
CR-IR 357 Service Manual
Appx_IN-9
Appx_IN-9