FujiFilm CR-IR 357 Service Manual page 48

3.
Once move the anti-topple retainer. Strike a center punch at the center of a
marked position to easily drill a hole.
014-204-01E
11.10.2005 FM4750
4.
Drill holes with a diameter of 12.5 mm and a depth of 35 mm at the four marked
positions.
CAUTION
When drilling a hole, wear protective goggles. Drilled chips might scatter.
 NOTE 
When drilling a hole, exercise care not to tilt the drill. If the drill is tilted, the anchor
nut cannot be embedded straight. As a result, there is possibility that the anti-topple
retainer cannot be correctly retained.
REFERENCE
When drilling a hole, use of a vacuum cleaner is recommended. If the hole is drilled
while sucking the chips by the vacuum cleaner, the depth of the hole can be easily
checked.
CR-IR 357 Service Manual
Appx_IN-4
Appx_IN-4