Appendix 7. Installing The Ru Software - FujiFilm CR-IR 357 Service Manual

Appendix 7. Installing the RU Software

This appendix describes the procedure for installing the RU software.
Before installing the RU software, you have to run a network check from the RU's machine
Maintenance Utility to verify the connection to the CR Console.
1. Verifying the connection to the CR Console
1.
Run a network check as directed under "8.4 Checking the Connection with the CR
Console."
{IN:8.4_Checking the Connection with the CR Console}
2. Installing the RU PC-TOOL
 NOTE 
If the RU PC-TOOL is already installed on the CR console, the step below need not be
performed. In such an instance, skip to "Appendix 7-3. Installing the RU software."
{IN: Appendix 7-3_Installing the RU Software}
1.
Install the RU PC-TOOL as directed under "8.5 Installing the RU PC-TOOL."
{IN:8.5_Installing the RU PC-TOOL}
3. Installing the RU Software
1.
Install the RU software as directed under "8.6 Installing RU Software."
{IN:8.6_Installing RU Software}
014-204-01E
11.10.2005 FM4750
CR-IR 357 Service Manual
Appx_IN-45
Appx_IN-45