FujiFilm CR-IR 357 Service Manual page 47

2. Securing the Machine with the Anti-Topple Retainer
1.
Assemble the anti-topple retainer to determine the locations where the anchor
nuts are to be embedded.
REFERENCE
The front bracket (for use on the front face) and the rear bracket (for use on the rear
face) of the anti-topple retainer have different shapes. Although they are of similar
shapes when viewed from the surface, you can distinguish them by checking from the
back.
The front bracket has nuts welded on the inner side.
The rear bracket has no nut welded on the inner side.
014-204-01E
11.10.2005 FM4750
2.
Place the assembled anti-topple retainer on the location where the machine is to
be settled. While holding not to cause the anti-topple retainer to shift, mark the
locations where the holes for embedding the anchor nuts are to be bored with a
pen or the like.
<Reference value>
CR-IR 357 Service Manual
Appx_IN-3
Appx_IN-3