FujiFilm CR-IR 357 Service Manual page 49

5.
Strike the anchor nut by a hammer to embed the nut into the four drilled holes.
 NOTES 
- When embedding the anchor nut, strike the top of the anchor nut vertically to the nut. If
the top of the anchor nut deforms, the bolt for retaining the bracket cannot be installed.
- Embed the anchor nut until its top does not protrude from the floor surface.
014-204-01E
11.10.2005 FM4750
6.
Place the anti-topple retainer in place. Put in spacers with thicknesses of 1 mm
and 2 mm into the bolt retaining positions on the rear side, and temporarily retain
the retainer with the button bolts.
 NOTE 
Be sure to use the button bolt as a bolt to retain the anti-topple retainer. If a common
bolt is used, the bolt head and the adjustable foot might come into contact when the
machine is moved, causing deformation on the adjustable foot.
CR-IR 357 Service Manual
Appx_IN-5
Appx_IN-5