FujiFilm CR-IR 357 Service Manual page 52

10.
Insert the front bracket from the front of the machine between the nut of the
adjustable foot and the bottom of the machine. While pushing the bracket against
the machine, fasten the nut of the adjustable foot for retaining.
 NOTES 
- Be sure to fasten the nut while pushing the bracket against the machine. If the bracket
is pushed insufficiently, the machine may not be able to be properly retained.
- When fastening the nut of the adjustable foot, exercise care not to cause an aperture
between the two nuts. The bracket might not be able to be properly retained.
014-204-01E
11.10.2005 FM4750
11.
Slowly move the machine toward the bracket retained on the floor, until the
bracket on the rear of the machine comes against the bracket retained on the
floor.
 NOTES 
- If the machine cannot be moved as the bracket retained on the bracket comes into
contact with the bracket mounted on the machine when the machine is to be moved,
height adjustment is necessary with additional spacers. Take the procedure 12.
- If the machine can move until the bracket on the rear of the machine comes against
the bracket retained on the floor, the procedure 12 need not be taken. Proceed to the
procedure 13.
CR-IR 357 Service Manual
Appx_IN-8
Appx_IN-8