Chapter 5 Preparation for Use of Endoscope
5.3
Connecting Endoscope
(1) Insert the LG connector of the endoscope into the
endoscope socket on the light source.
(2)
Insert the video connector of the endoscope into the video
connector socket on the processor.
[Note]
Place the waterproof cap on the edge of the tray.
(3) Connect the dedicated connector cap to the connector
socket not in use.
(4) Insert the connector of the water tank into the feed water
connector on the endoscope.
5-8
Do not touch the LG connector tip until it cools down (approximately 5
minutes).
Touching the LG connector with hands immediately after use of the
endoscope may cause a burn injury.
CAUTION