FujiFilm CR-IR 357 Service Manual page 71

3.
Drill holes with a diameter of 12.5 mm and a depth of 35 mm at the four marked
positions.
CAUTION
When drilling a hole, wear protective goggles. Drilled chips might scatter.
 NOTE 
When drilling a hole, exercise care not to tilt the drill. If the drill is tilted, the anchor nut
cannot be embedded straight. As a result, there is possibility that the supporter cannot
be correctly retained.
REFERENCE
When drilling a hole, use of a vacuum cleaner is recommended. If the hole is drilled
while sucking the chips by the vacuum cleaner, the depth of the hole can be easily
checked.
014-204-01E
11.10.2005 FM4750
4.
Strike the anchor nut by a hammer to embed the nut into the four drilled holes.
 NOTES 
- When embedding the anchor nut, strike the top of the anchor nut vertically to the nut. If
the top of the anchor nut deforms, the bolt for retaining the bracket cannot be installed.
- Embed the anchor nut until its top does not protrude from the floor surface.
CR-IR 357 Service Manual
Appx_IN-27
Appx_IN-27