ProSoft Technology PS69-DPM User Manual page 88

Contents
User Manual
CIP Extended
Status Status
15 hex 0000 hex
16 hex 0000 hex
FE hex 0000 hex
FF hex 0514 hex
FF hex 0517 hex
DDLM_Slave_Diag
Failure Significance
0 Service could be executed without an error
17 No response from the station
18 Master not into the logical token ring
161 Remote Address in request service out of
range
DDLM_Global_Control
The DDLM_Global_Control command initiates a multicast command on the PROFIBUS
network to all configured slaves. Therefore, this command is always assumed to be
successfully executed and no error will be placed in Cnf.Failure of the answer message.
Failure Significance
0 Service was executed without an
error
DDLM_Set_Parameter
Failure Significance
0 = Service was executed without an
CON_OK error
2 = Resource unavailable
CON_RR
3 = Requested function of Master is not
CON_RS activated within the Slave
Page 88 of 130
Meaning Cause
Configuration data Too much data transferred with
size too large the CIP Message
Object not supported The requested object does not
exist within the module.
Message Timeout No answer message was
received.
General Error
Non specified error
occurred
General Error The value in Req.Command is
unknown
Unknown command
Error source
Error source
Slave
Slave
PS69-DPM ♦ CompactLogix or MicroLogix Platform
Help
Check if the overall length of the
requested command send with
the CIP message and the
consistency of all length
parameter within the requested
command is correct.
Call support
The value Req.Command must
be initialized
Error source Help
DEVICE Check network wiring, check bus
address of slave or baud rate
support
Network in general Check master DP-Address or
highest-station-address of the
Master. Examine bus wiring for
bus short circuits
HOST Check parameter in request
message
Help
Help
Slave has no buffer space left for the
requested service
Remote SAP is not activated
PROFIBUS DPV1 Master
ProSoft Technology, Inc.
October 1, 2014