YOKOGAWA ZR22G User Manual page 68

<Wall Mounting>
(1) Drill mounting holes through the wall as shown in Figure 3.10.
4 - ø6 hole
194
Wall mount hole
4 - ø6 hole
190
Wall mount hole （/BR）
Figure 3.10 Mounting holes
(2) Mount the converter. Secure the converter on the wall using four screws.
<Panel Mounting>
(1) Cut out the panel according to Figure 3.12.
4-R8 to R10, or 4-C5 to C8
183
+2
0
Figure 3.12 Panel cutout sizes
(2) Remove the fitting from the converter by loosening the four screws.
(3) Insert the converter case into the cutout hole of the panel.
(4) Attach the mounting fitting which is once removed in step (2) again to the converter.
(5) Firmly fix the converter to the panel. Fully tighten the two clamp screws to hold the panel
with the fitting.
Figure 3.11 Wall Mounting
Mounting fitting
Figure 3.13
<3. Installation>
Washer
Screw
Clamp screw
Panel mounting
IM 11M12G01-02EN 1sh Edition : Mar. 25, 2021-00
3-9